Description
Flow Rate Characteristics
Materials of Construction
| Filter Media | PES Membrane |
| Cage/Support | Polypropylene |
| Core/End Caps | Polypropylene |
Operating Conditions
| Maximum Temperature | 90°C |
| Max.Differential Pressure | 4.0bar / 21°C (forward) |
| 2.4bar / 90°C (forward) | |
| Effective Filtration Area | 0.58m2/ μ 68-10 inch |
Sterilization
| Inline Steam Sterilization | up to 30 cycles (135°C for 30min@30kPa per cycle) |
| Autoclave | up to 30 cycles (130°C for 30min per cycle) |
Integrity Test Data
| Bubble Point | BP : ≥ 0.32 MPa (water), 0.22 μm |
| BP : ≥ 0.20 MPa(water), 0.45 μm | |
| Diffusion Flow | DF : ≤ 25 ml/min/10”@ 0.275 Mpa, 0.22 μm |
| DF : ≤ 25 ml/min/10”@ 0.15 Mpa, 0.45 μm |
Ordering Information
| Removal Ratings | End Cap | Nominal Length | Seal Material |
| 0010=0.1μm | HSF=226 /Fin (PBT Insert) | 05=5″ | S =Silicone |
| 0022=0.22μm | HSC=226 /Flat (PBT Insert) | 10=10″ | E =EPDM |
| 0045=0.45μm | HTF=222 /Fin (PBT Insert) | 20=20” | V =Viton |
| HTC=222 /Flat (PBT Insert) | 30=30” | ||
| DOE=Double Open End | 40=40” |
